This is an old revision of the document!
Engineering Design Studio (A5, 015)
Sunday, September 24, 2017, 9:00 am – 11:40 am
During the last 30 minutes of class there will be an introduction to the Engineering Design Studio's laser cutter.
Build a cardboard prototype that visualizes one of the Kinematic Models from the Cornell Reuleaux Collection. Get inspired by going through the examples from the following website: https://www.robives.com/mechs It might be good to take part at an introductory session of how-to-not-use-a-laser-cutter by Esteban!
Feel free to also check out the following books from the EDS library: